Meyer MDV Series Manual de instrucciones descargar pdf (Pagina 13)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES



Fig. 3: Base Unit layout (Figure shown without Base Unit Cover)

Programming/Reprogramming the Transmitter and the Base Unit:

Tools needed: A small “phillips” screwdriver and a small diameter pin (paper clip).

Instructions to program Transmitter and Base Unit:

1. Remove (4) screws and cover on Base Unit.

2. Power-up the Base Unit. Connect a 12V power source to the spreader 12V battery terminals and

plug the engine wire harness to the Base Unit wire harness (see Male Connector in Fig. 3). DO

NOT DISCONNECT THE BATTERY TERMINALS from the 12V source when engine is running.

3. On the backside of the Transmitter depress the “ADD

” button (see Fig. 2) using a small pin or

paper clip – You will see a “blue” LED start to blink (for approximately 15-17 seconds).

4. On the front side of the Transmitter press all (8) buttons (see Fig. 1). There is no certain order to

press the buttons. Firmly press each button, separately. Perform this step before the 15-17 seconds

are up (before “blue” LED stops blinking). The Transmitter is now programmed and has created its

own 1 in 16 million address. Once the “blue” LED stops blinking, this step is completed.

5. On the Base Unit (see Fig. 3) press the black “LEARN

” button. The “red” LED will start to blink

(for approximately 15-17 seconds).

6. On the front side of the Transmitter you only need to press Button #1 (clutch on/off), once.

Perform this step before the 15-17 seconds are up (before “red” LED stops blinking). The base unit

has now recognized the Transmitters unique 1 in 16 million address. Once the “red” LED stops

blinking, this step is completed.

7. Verify the (5) functional buttons (Buttons #1, #3, #4, #5, & #6) on the Transmitter are working with

the Spreader Unit by pressing each button, individually (the Base Unit “red” LED will flash when a

Transmitter button is pressed). If Transmitter buttons are not working, repeat steps 3 – 8 or see the

Trouble shooting directions.

8. When Transmitter buttons are functioning properly, re-assemble the Cover on the Base Unit with

the (4) screws. Your Swenson Wireless Controller is now ready to use!

“LEARN” Button

(

“

lack”

ress button

)

Programming “red” LED

Antenna (coiled) Male Connector

3        NOVEMBE

PAGE 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Sin comentarios

Meyer MDV Series Manual de instrucciones Pagina 13