Meyer MDV Series Manual de instrucciones descargar pdf (Pagina 14)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES



Transmitter Battery Replacement

The Transmitter uses a standard CR2032 lithium button cell battery. In normal use it will provide 1 to 2

years of operation. To replace the Transmitter battery, gently press and slide the battery cover off.

Remove the battery by sliding (NOT lifting) it out from underneath the retainer (see Fig. 4). Observe the

battery polarity when replacing (“+” showing face up).

otes:

1. If the battery looses power or is removed the Transmitter and Base Unit may need to be reprogrammed

(see reprogramming Transmitter and Base Unit instructions). Check Transmitter functional buttons to

verify if reprogramming is necessary.

2. When removing lithium battery, please use caution to slide not lift the battery from the controller! If

excess force is used to remove the battery (example: lifting the battery with a small screw driver) – the

solder connections from the battery clip to the circuit board could be pried loose. This action is not

covered under warranty.

Fig. 4: Back of Transmitter with back cover and battery removed

Other Considerations

1. Powering off the engine will not automatically power off the Clutch (engagement of

conveyor/spinner). If clutch remains engaged, after engine is turned off, it could lead to a slow

electrical drain on the 12V battery.

2. If an unregulated voltage (example: sparking the battery cable terminal to the 12V battery post.) is

sent to the Base Unit it could erase the Base Unit programming. The remote may show signs of

no longer working with the Base Unit. Reprogramming will be required. When 14Amps are

supplied the Base Unit circuit board is designed to shut off. See additional trouble shooting

comments.

3. Only one transmitter at a time can be activated within a reception area. Only one carrier of a

particular frequency may occupy the same airspace at a given time. This means that if two

transmitters are activated in the same area at the same time the signals will interfere and the decode

on the receiver will not see a valid transmission and the wireless controller will not function.

4. Multiple Transmitters can be programmed to (1) Base Unit.

5. To verify the Base Unit is receiving a signal from the Transmitter. Press a button on the Transmitter -

“red” LED on the Base Unit will light-up.

6. Swenson Spreader, LLC has no control over the intended usage of this product. Because of that

Swenson Spreader, LLC offers no written or expressed liability as to how this product is used.

Swenson S

reade

, LLC recommends that these units are intended for OFF ROAD USE ONLY!

Transmit

Lithium batter

Battery Cove

3       NOVEMBER 

PAGE 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Comentarios a estos manuales

Sin comentarios

Meyer MDV Series Manual de instrucciones Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Esparcidor Meyer MDV Series