Meyer MDV Series Manual de instrucciones descargar pdf (Pagina 15)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES



TROUBLE SHOOTING

1. To verify the Transmitter and Base Unit are working together: Once the base unit has power the

“red” LED will come on when the Transmitter buttons are depressed (Cover of Base Unit will need

to be removed to see “red” LED). If the “red” LED does not come on, the Base Unit is NOT

getting a signal from the Transmitter.

Possible Solutions:

A. Reprogramming the Transmitter and Base Unit might be required.

B. Base Unit might not be functioning properly (see Base Unit trouble shooting below).

C. Transmitter might not be functioning properly. (see Transmitter trouble shooting below).

2. Base Unit Programming Lose:

If an unregulated voltage (spark) is sent to the Base Unit from a

power source the Base Unit could lose its programming. The voltage spike will not damage the

Base Unit or Transmitter. Unregulated voltage could generate from the following:

- Connecting battery cables to a 12V battery source.

- Jump starting the 12V battery.

- Charging the 12V battery.

- Pull-starting the engine.

Possible Solutions:

A. Reprogramming the Transmitter and Base Unit may be required.

B. Base Unit might be damaged, a new Base Unit & Transmitter will need to be ordered.

3. Base Unit does not function properly:

(example: “red” LED will not light up when “LEARN”

button is depressed on Base Unit).

Possible Solutions:

A. Check/verify voltage of 12V is being supplied by the 12V battery. Lower voltages than 12V

will not allow the Base Unit to function properly.

B. Confirm all wires on engine wire harness are secure and properly connected.

C. Base Unit could be damaged, a new Base Unit & Transmitter will need to be ordered.

4. Transmitter does not have power:

(example: “blue” LED will not light up when “ADD” button is

depressed on Transmitter).

Possible Solutions:

A. Verify tool diameter (example: paperclip) to depress Transmitter “ADD

” button is small

enough to enter the “ADD

” button hole.

B. Verify the lithium button cell battery polarity is correct (“+” will be facing up).

C. If the Transmitter is 1-2 years old, check the lithium battery voltage with a meter or replace the

battery as needed (CR2032 lithium button cell battery).

D. Transmitter could be damaged, a new Transmitter will need to be ordered.

5. General troubleshooting:

A. Try to Program/reprogram the Transmitter and Base Unit.

B. Verify the Ground wires (all wires) are secure.

C. Check connections to the components that the unit is trying to operate using a voltmeter.

WARNING

1. Disconnecting 12V Battery Cables/Terminals:

A. DO NOT DISCONNECT THE BATTERY (CABLES/TERMINALS) WHEN THE ENGINE

IS RUNNING. This could disable or permanently damage the Base Unit.

For further technical assistance please contact Swenson Spreader, LLC at (888) 825-7323 or visit us at

meyerproducts.com to download updated Wireless Controller Instructions.

3       NOVEMBER 

PAGE 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 75 76

Comentarios a estos manuales

Sin comentarios

Meyer MDV Series Manual de instrucciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Esparcidor Meyer MDV Series