Meyer MDV Series Manual de instrucciones descargar pdf (Pagina 8)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES







 A pipe joint sealant compatible

with hydraulic oil must be applied to all NPT fittings.

Teflon Tape Sealant Is Not Recommended. Do not apply

pipe joint sealant to ORB or JIC fittings.

2. Hose ends connected to flow valve must be of the

“swivel”, type.

3. CAUTION: Over tightening of the fittings in flow

valve may cause damage to valve body.

4. Approximately 8” of hose slack must be realized

between the flow valve and valve stand after the flow

valve has been completely plumbed. If this condition

does not exist after the plumbing has been completed,

removal of valve will require hoses to be removed at

opposite end of valve.

5. Assembly of valve on stand.

A. Cut a 5” x 5” square opening in floor board

of truck where the valve stand is to be located.

B. Bolt valve stand halves together forming a,

box over the 5” x 5” square opening. NOTE:

When bolting valve stand halves in place, make

sure holes in flanges align with holes in flange

plate.



C. Bolt flange plate to VALVE (Use (2)

1/4” X 3” bolts, lockwashers, etc.)

D. Insert hoses through floor opening and valve

stand and connect appropriate hoses (see

instruction #1 thru #4) to flow valve.

E. Bolt flange plate to valve stand flanges.

(SEE PAGE XX PARTS LIST)

00122-588-03 NOVEMBER 2009

PAGE 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 75 76

Sin comentarios

Meyer MDV Series Manual de instrucciones Pagina 8